In poultry production, the whole flock is generally treated by adding this compound to the drinking water, whereas, in cattle or pig production, treatment is often restricted to diseased animals. As a result, the highest levels of quinolone resistance are found in Campylobacter isolated from chicken (Gallus gallus) [12]. Fluoroquinolones are categorized as critically important drugs for human medicine by the WHO [13], and consequently Selleckchem Pifithrin�� surveillance programs to monitor trends in use [14]
and resistance [15,16,12] have been implemented. For Campylobacter, the principal molecular mechanisms of quinolone resistance consists in a single mutation C257T in the gyrA gene [17,18]. Consequently, PCR or sequenced-based methods targeting this quinolone resistance determining region (QRDR) have been shown to be highly predictive for detecting phenotypically resistant variants [16]. Moreover, previous work on gyrA suggested this locus might provide a host signature and thus be a good candidate for typing purposes [19,20]. The aims of this study were thus to evaluate the host specificity of the gyrA gene and to monitor quinolone resistance in a large Campylobacter jejuni and coli strain collection
originating from domesticated animals and surface water samples potentially contaminated by wildlife. Methods Isolates from non-human sources For this study, we characterized 430 C. jejuni and 280 C. coli isolated in Luxembourg from surface waters (SW), domesticated
mammals (DM) and poultry (P) between 2005 and 2012. Identification to the species selleck chemical level of the isolates was previously achieved buy Sirolimus by a duplex real-time PCR targeting the hipO gene of C. jejuni and a conserved region of the gyrA gene of C. jejuni and C. coli (outside the QRDR). Primer and probe combinations for the hipO Taqman-qPCR and gyrA FRET-qPCR systems were selected from published methods [21,22]. Real-time PCRs were performed using the FastStart DNA Masterplus HybProbe kit (Roche Diagnostic, Prophac, Luxembourg) in a total reaction volume of 20 μl containing the following final primer and probe concentrations: hipO primers 0.5 μM, hipO Taqman probe 0.1 μM, gyrA primers 1 μM and gyrA sensor and anchor probes 0.2 μM. The PCR programme included an initial activation step of 10 min at 95°C, 30 amplification cycles of 6 s at 95°C, 12 s at 54°C and 25 s at 72°C, followed by a melting curve analysis step of 1 min at 95°C, 50 s at 38°C, a rise to 80°C with an increase rate of 0.1°C s−1, and final cooling of 30 s at 40°C. C. jejuni and C. coli were identified by reading both the amplification and melting curves. Isolates with an atypical profile (i.e. hipO negative and a gyrA melting curve corresponding to no known species) were further confirmed as C.