The pressure drop at the capillary tip was kept constant at 1.5 bars by adjusting the orifice gap area at the nozzle.The flame height was observed to be approximately 10�C12 cm, and was increased slightly by increasing the combustion enthalpy. The combustion enthalpies are directly dependent on the particular solvent, starting materials and dopants. All samples showed a yellowish-orange flame as seen in Figure 1. The temperatures for the spray flame were typically in the range of 2,000 K to 2,500 K [37]. The liquid precursor mixture was rapidly dispersed by a gas stream and ignited by a premixed methane/oxygen flame. After evaporation and combustion of precursor droplets, particles are formed by nucleation, condensation, coagulation, coalescence, and Pt deposited on ZnO support.

Finally, the nanoparticles were collected on glass microfibre filters with the aid of a vacuum pump. Undoped ZnO nanopowder was designated as P0 while the ZnO nanopowders doped with 0.2�C2.0 at.% Pt were designated as P1�CP5, respectively. Powders of the various ZnO samples were characterized by X-ray diffraction (XRD) and the specific surface area (SSABET) of the nanoparticles was measured by nitrogen adsorption (BET analysis), scanning electron microscopy (SEM) and transmission electron microscope (TEM).Figure 1.Spray flame (0.5 M zinc naphtenate and Pt (acac)2 in xylene) of (a) pure ZnO, (b�Cf) 0.2�C2.0 at.

% Pt/Z
Underwater Acoustic Sensor Networks (UWA-SNs) have recently been drawing much attention because of their potential applications ranging from oceanographic data collection, environment monitoring, structure monitoring, tactical surveillance to disaster prevention [1, 2].

However, UWA-SNs are very different from existing terrestrial sensor networks due to the properties of the underwater environments. Firstly, UWA-SNs use acoustic signals to communicate, thus the propagation delay Cilengitide is large due to the slow acoustic signal propagation speed (1.5 �� 103m/s). Secondly, the underwater acoustic communication channel has limited bandwidth capacity because of the significant frequency and distance dependent attenuation. Currently, the limit on available underwater bandwidth is roughly 40 km��kbps [3, 4].

Thirdly, due to economics and the potentially large areas of interest in the ocean, GSK-3 UWA-SNs are mainly sparse networks nowadays [2, 3]. For such networks, instead of randomly deploying the sensor nodes, it is common to deploy the nodes manually with help of ships [5].To deploy such a long-term UWA-SNs, one of the main challenges is the limited energy resources of the sensors because they are battery-powered and it is even harder to recharge node batteries in underwater environments.