After that, the AsH3 flow was removed from the chamber, while TMS

After that, the AsH3 flow was removed from the chamber, while TMSb (6.75×10−5) and TMIn (4.5×10−6) flows were simultaneously introduced into the reactor chamber to initiate the growth of InSb NWs. The

InSb NWs were grown for 40 min and then cooled down with the protection of only hydrogen flow (TMIn and TMSb flows were removed from the reactor chamber during cooling). For comparison, InSb layers were also grown directly on Si (111) under the same growth conditions but without InAs seed layer. The morphology of InSb structures was characterized with field-emission scanning electron microscopy (FE-SEM; JSM-6700 F, JEOL, Akishima-shi, Japan)and transmission electron microscopy (TEM; Tecnai G20, 200 keV, FEI, Hillsboro, OR, USA). Raman scattering measurements were performed in a backscattering geometry at room temperature with a Jobin Yvon HR800 confocal micro-Raman spectrometer (HORIBA, #TGF-beta inhibitor randurls[1|1|,|CHEM1|]# LY3023414 datasheet Kyoto, Japan), in which a 514.5-nm line of an Ar-ion laser was used as the excitation source with the focus size around 1 μm and excitation power of 0.5 mW. Results and discussion Figure 1 shows the SEM images of InSb structures with and without InAs seed layer. Clearly, InSb NWs are formed in the sample

with InAs seed layer, while no InSb NWs are observed in the sample without InAs seed layer. For the latter case, as shown in Figure 1b, only particle-like morphology is observed, instead of NWs. This indicates that InAs seed layer plays an important role in growing InSb NWs. Epitaxial growth of InSb is not trivial due to its large lattice constant (a 0 =

0.648 nm) compared to other III-V-semiconductor materials. As reported in our previous work [11], vertical InAs NWs can be directly heteroepitaxially grown on Si substrates at about 550°C (Additional file 1: Figure S1 and Additional file 2: Figure S2). Therefore, the InAs seed layer deposited at 550°C can form InAs NWs, which provide a template for the subsequent growth very of InSb NWs. With the growth temperature being reduced to 440°C, TMIn and TMSb are introduced into the reactor chamber, and the InSb growth is initiated on the template provided by the InAs seed layer, which facilitates the formation of InSb NWs. This growth mechanism is confirmed by the chemical composition distribution along the InSb NWs, which will be discussed later. It should be noted that the parasitic growth of non-wire-like InSb material is also observed in the form of InSb structures with non-well-developed crystal faces [12]. All vertical InSb NWs are grown along the (111) direction perpendicular to Si substrate, as shown in Figure 1a. Figure 1 SEM images of InSb NWs grown on Si substrate. SEM image of the InSb NWs grown with (a) and without (b) InAs-seed-layer (tilt 45°); (c) side view of the InSb NWs showing a clear metallic droplet on their top.

Comments are closed.