The electrical characteristics of the RRAM devices were measured using an Agilent 1500A precise semiconductor analyzer (Agilent Technologies; Santa Clara, CA, USA) on a variable temperature probe station. The bias was applied at TE, and the BE was connected to ground. learn more Figure 1 Schematic illustration of the Ag/AlO x /Pt RRAM devices. The 60Co γ ray radiation is performed after the device is fabricated. Results and discussion Figure  2 shows the typical current versus voltage (I-V) curves of the Ag/AlO x /Pt RRAM devices with different radiation total dose. A forming

process is needed to firstly turn the devices on. All SBI-0206965 in vivo samples exhibit stable bipolar switching behaviors with set and reset voltages at approximately +1.0 and -2.0 V, respectively, so that the switching mode has Ferrostatin-1 clinical trial not been changed by the radiation. The switching mechanism of this kind of RRAM devices has been well studied, which is the formation and rupture of the metallic filaments (Ag) in the oxide film at positive and negative TE bias, respectively [17–20]. Figure 2 Typical I-V curves of Ag/AlO

x /Pt RRAM devices with different total radiation dose. The bipolar resistive switching is still stable after the γ ray radiation. To investigate the TID radiation impact on the performance of resistive switching memory, at least 15 samples of each RRAM device were measured and analyzed by using a statistical method. Figure  3a shows the initial resistance of the devices, in which an obvious degeneration of uniformity can be found. The resistance reduction of some samples can be observed after the radiation, and the amount of low-resistance samples increases with the Rucaparib concentration radiation dose. It is resulted from the radiation-induced soft breakdown in AlO x film of the RRAM device, and several conducting paths are created by the radiation [21]. As the radiation dose increases, there arise more conducting channels within the film, turning more fresh devices to the low resistance. The initial resistance failure can be recovered by a reset operation through a negative TE bias sweep, bringing the device back to the high

resistance state (HRS). Figure  3b presents the distribution of the resistance in HRS and low resistance state (LRS) for the samples. It is reported that holes will be generated by the γ ray in AlO x film, and an increase of tunneling leakage current can be induced by these holes [22]. The resistance at HRS is mainly determined by the resistance of the resistive switching layer [11], so that the increase of leakage paths will lead to the decrease of resistance at HRS. On the other hand, the resistance in LRS is mostly related to the Ag filament. Thus, there is nearly no change of the resistance in LRS after the γ ray radiation. Figure 3 Resistance distributions of the Ag/AlO x /Pt RRAM devices. Distribution of (a) the initial resistance and (b) the resistance in HRS and LRS of the devices with different radiation doses.