Upon the autopsy, pigs were extubated and tubes were stored AZD6738 mouse at −80 °C for subsequent analysis. Then, to prevent any disruption of the biomatrix and impairment of bacterial viability, prior microscopic analyses, the ETTs were slowly unfrozen up to room temperature. The ETT exterior surface was cleaned with sterile gauzes and decontaminated through careful rinsing with 80% alcohol and saline solution. Using strict aseptic technique, two 1-cm-long sections of the distal dependent part of the ETT were excised

(Fig. 1). A 1-cm cross-section of ETT was immersed in a 1 mL phosphate buffer solution (PBS), stained with live/dead® BacLight kit™ (BacLight kit™; Invitrogen, Barcelona, Spain) for 15 min protected from the light, and then rinsed with PBS. The staining conditions were as follows: 1.5 μL of SYTO® 9 (stock 3.34 mM DMSO) and 1.5 μL propidium Palbociclib nmr iodide (stock 20 mM DMSO) in 1 mL PBS. During CLSM imaging, SYTO® 9 emits green fluorescence and is used to identify living microorganisms with intact membrane whereas propidium iodide (PI) emits red fluorescence and stains dead bacteria with damaged membrane. A Leica TCS SP5 laser scanning confocal system (Leica Microsystems Heidelberg GmbH, Manheim, Germany) equipped with a DMI6000 inverted microscope and a 20xPL APO numerical

aperture 0.7 objective were used. SYTO® 9 and PI images were acquired sequentially using 488-, 561-nm laser lines, an acousto optical beam splitter and emission detection ranges 500–550, 4-Aminobutyrate aminotransferase 570–620 nm, respectively. The confocal pinhole set at 1 Airy units. Pixel size was 160 nm. All samples and slides were coded to ensure that the image acquisition and measurements were blinded. The first author and an experienced CLSM facility manager made all observations and pictures. We analyzed 127 CLSM images (69 for the control, 37 for the linezolid, and 21 for the vancomycin group). Biofilm

viability was computed using image j software (Wayne Rasband, NIH). Regions of interest of each image were drawn by the operator to select all bacterial aggregates and exclude areas of eukaryotic cells; selection of these regions was based on cell size, morphology, and overall consistency of these factors within the area. Then, to select and independently measure the areas of live and dead bacteria, threshold limits were set for SYTO® 9 and PI channels, respectively. Only thresholded pixels were included in area measurements. For each image, we measured total area of bacteria (comprising live and dead bacteria), area of live bacteria (green), and dead bacteria (red) to evaluate differences in bacterial presence and viability among groups of treatment. We quantified the ratio between the total area of bacteria and the area of image examined, expressed as percentage. The live/dead bacterial ratio was calculated as the ratio between the area of live bacteria and the area of dead bacteria.